Type Description
6620×4
66 series number
20: pump type
4: four-stage impeller series connection
Application
66 series pump is single suction multistage submersible pump that can applied to farm irrigation, garden sprinkling, fountain landscape, rainwater recycling system, mining drainage, emergency rescues, urban water supply, enterprise and government intuition water lifting. It can be used in horizontal position(while its service life will be inferior to that of vertical using). This product has some advantages of low noise, high efficiency and energy saving.
Its suitable for enterprises and public institutions such as bath center, district heat supply, power generation, underground hot water lifting. Different specifications and types provided for different wells.
Structure description
66 series submersible pump applies the space conductance guide valve structure, and it composes of pump, motor, controller. The pump contains working part, pipe (including check valve ).
1) working part
For pumps with strong axial force, we equipped with balance hole in order to relieve the pressure, then the motor could bear the rest.
We are strict about the concentricity and axial movement. With exquisite accessories and accurate axial locating dimension, the machine has a long service life and can be operated smoothly and reliably.
2) Pipe
The pipe contains check valve, discharge pipe and pump frame. Outlet of check valve is connected with the discharge pipe to prevent the water regorging when the power is cut off. Water flows out from check valve through discharge pipe, pump frame, ground gate valve and pipes to the destination. The pump frame is fastened on the concrete plinth, supporting the whole weight of the pump.
Medium Range
1 Clean water, cold water, rainwater, gushing water of mining, drinking water,etc.
2 Water temperature range: +5--+105℃
3 Solid content (mass ratio): ≤0.01%
4 PH: 6.5-8.5
5 H2S content: ≤1.5mg/L
6 Cl- content: ≤400mg/L
7 The full set must be submerged into water completely in vertical position and the model must be matched with the well diameter.
Motor Parameter
The submersible motor is lubricated by clean water. It must be filled with clean water, or else its service life will be lessen. If you forget filling, the motor will be broken.
Motor protection level: IPX8
Insulation Class: E
Power Source
Low-voltage: 380v/ 50HZ, or 660v/ 50Hz
High- voltage: 3000v/ 50HZ, or 6000v/ 50HZ
If you need special voltage or frequency, please inform us in advance.
Material
1 Impeller: Cast iron, gray iron200, or tin bronze, such as ZCuSn3Zn8Pb6Ni1
2 Pump bowl: Cast iron, gray iron200, or stainless steel, such as 2Gr13 .304
3 Pump shaft: stainless steel 2Gr13(1050thermal refining, enhancing torsional moment)
4 Tension bolt: made by cutting 20# steel, the end part is welded by stainless steel 304.
5 Check valve: body, seat ZG230-450; plate, ring, valve rod Cr17Ni2
6 Interface shim: rubber asbestos plate
7 Motor Seal: Rubber O-ring seal, mechanical seal
8 Motor regulating sleeve: rubber
Advantage
1 Easy installation
2 Low noise, high temperature resistance, long service life.
3 Exterior check valve, convenient to maintain and exchange, avoiding water hammer impact
4) High lift with single-stage, lower the whole sets height, enhance stability; the bearing bush is made of tin bronze.
Supplys
Ritz submersible pump set(including the body and motor). You also can choose one of them.1 flange matching with outlet, 1 maintenance instruction, 1 conformity certificate, 1 packing list, wooden external packing.
|
